For this month’s Tim Holtz 12 Tags of 2016 I thought I would take a break from the usual large tags I have made, and make a short, fat one instead.  I used the “Love From”  Tag Die Set from Tonic Studios.

In Tim’s example tag he uses his new Mosaic kit.  This is not yet available in the United Kingdom so I have attempted to create a similar effect using the supplies I have to hand.

I cut the main tag shape from 300gsm black card (it has a bit of a canvas texture on it) and used the oval die to cut white 300gsm stamping card.

DieCutTonicTags

Next I inked up the white card oval using Distress Inks.  I used Fossilized Amber all over the oval then blended Spiced Marmalade around the edges.  I wanted an irregular look.

DistressInkOnOval

I then ran the oval through my Big Shot machine inside the wood-grain embossing folder from Crafters Companion.  I love the effect this gives.

WoodGrainEmbossing

Using Brushed Corduroy Distress Ink, I darkened the raised parts of the wood grain.  I kept the blending tool vertical and dragged it width-ways over the oval.  In this picture I have done the right hand side only.

InkingTheWoodgrain

A added a bit more of the Brushed Corduroy Distress Ink around the edge of the oval and glued it to the black tag.  I made two little beads of Dovecraft 3d Pearl Effects in each corner and put this aside to dry.

AddedGoldDots

I cut a butterfly from 300gsm Centura Pearl card using one of the shadow dies from the Paper Artist 3 Butterflies and Shadows die set by Hot off The Press.

ButterflyDieCut I coated the die cut butterfly with modelling paste then pressed a dryer sheet into it to give it some texture.  Here I have laid it on the black tag so you can see it clearly, it is not glued down.  I left this to dry for a couple of hours, to be sure.TexturePasteonButterfly

I cut a pile of tiny pieces from some scraps of coloured paper and began to stick them to the butterfly with Ranger Multi Medium Matte.  This was quite fiddly and took a while.  I coated all the pieces with the Multi Medium to ensure they were all glued down properly.  I then left it whilst I had a cup of tea,  to ensure it was all dry.

MosaicPiecesGoingOnMosaicedButterflyI coated each of the piece of paper on the butterfly with a thin layer of Ranger Glossy Accents.  I used a cocktail stick to push the Glossy Accents into the corners of the pieces.  Again I left it to dry thoroughly.  The 3d tiled effect looks far nicer in real life than in pictures,  honest.

AddingGlossyAccents

I put some sticky foam behind the butterfly and fixed it to the tag.ButterflyAdded

Next I stamped the word “Love” in Memento Tuxedo Black ink.  This stamp is part of a set called Flutterby from Debbi Moore.StampedLove

I applied the Fossilized Amber Distress Ink all over the word, cut it out and added a little Spiced Marmalade around the edges.  I mounted it on a piece of white paper to give a tiny mount.  I coloured the word in with a Brushed Corduroy Distress Marker and added some little faux stitches with a white Uniball Gel Pen.  The word is more distinct in real life than it appears in the pictures.  I fixed the “Love” to the tag with sticky foam squares.

LoveSentiment

And finally a green ribbon to finish.

FinishedButterflyTag TTAprilTag

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *